MATERIAL SAFETY DATA SHEET

HILTI, INC.:
P.O. Box 21148
Tulsa, OK 74121
Ph: 1 800 879 6000
Emergency No.: 1 800 879 4444

PRODUCT NAME: Air Tool Lubricant

DESCRIPTION: Petroleum based lubricating oil

INGREDIENTS AND EXPOSURE LIMITS

PEL = OSHA Permissible Exposure Limit. TLV = ACGIH Threshold Limit Value. These are 8 hour time-weighted averages unless otherwise indicated by "C" (Ceiling) or "STEL" (Short Term Exposure Limit). NE = None Established. * indicates "as oil mist".

PHYSICAL DATA

FIRE AND EXPLOSION HAZARD DATA

FLASH POINT: 365°F, COC FLAMMABLE LIMITS: Not Applicable

EXTINGUISHING MEDIA: CO₂, Dry Chemical, Foam

SPECIAL FIRE FIGHTING PROCEDURES: A self-contained breathing apparatus should be worn when fighting fires involving chemicals.

UNUSUAL FIRE AND EXPLOSION HAZARDS: None known. Thermal decomposition products can be formed. See below.

REACTIVITY DATA

STABILITY: Stable INCOMPATIBILITY: Strong oxidizers

CONDITIONS TO AVOID: Contact with strong oxidizers.

HAZARDOUS POLYMERIZATION: Will not occur.

HAZARDOUS DECOMPOSITION PRODUCTS: Carbon monoxide and oxides of sulfur can form upon incomplete combustion.

HEALTH HAZARD DATA

KNOWN HAZARDS: Can cause eye irritation. Prolonged and repeated overexposure to the skin can cause irritation and dermatitis.

CARCINOGENICITY: No ingredients are classified by IARC, NTP, or OSHA as known or potential carcinogens.

PRIMARY ROUTES OF EXPOSURE: Dermal. Inhalation.

SIGNS AND SYMPTOMS OF EXPOSURE: None expected. Exposure to oil mists can cause respiratory irritation. Chronic exposure to the skin can cause dermatitis.

MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: Eye, skin, and respiratory conditions.

EMERGENCY AND FIRST AID PROCEDURES

EYES: Flush with plenty of water. Get medical attention if symptoms persist.

SKIN: Wash with soap and water. Contaminated clothing should be laundered before reuse.

INHALATION: Not considered a route of exposure. Product has a very low vapor pressure.

INGESTION: Do not induce vomiting unless directed to by a physician. Get medical attention. (Note to Physician: Material, if aspirated into the lungs, can cause chemical pneumonitis).

OTHER: Referral to a physician is recommended if there is any question about the seriousness of the injury/exposure.

CONTROL MEASURES AND PERSONAL PROTECTIVE EQUIPMENT

VENTILATION: General (i.e. natural or mechanically induced fresh air movements that maintain vapor concentrations below recommended exposure limits).

EYE PROTECTION: Safety glasses are recommended for most industrial settings.

SKIN PROTECTION: Not required. Gloves recommended (cotton gloves are adequate).

RESPIRATORY PROTECTION: Dust/mist respirator (e.g. 3M8710) should be used when exposure to mists is likely.

PRECAUTIONS FOR SAFE HANDLING AND USE

HANDLING AND STORING PRECAUTIONS: Avoid prolonged or repeated contact with skin. Avoid breathing mists or vapor. Wash thoroughly with soap and water after contact. Remove contaminated clothing.

SPILL PROCEDURES: Absorb with sand or inert material. Sweep or scoop up and remove. Prevent spread of spill into sewers and watercourses.

REGULATORY INFORMATION

HAZARD COMMUNICATION: This MSDS has been prepared in accordance with the federal OSHA Hazard Communication Standard.

HMIS CODES: Health 1, Flammability 1, Reactivity 0, PPE A

DOT SHIPPING NAME: Non-regulated.

TSCA INVENTORY STATUS: Chemical components listed on TSCA inventory.

SARA TITLE III, SECTION 313: This product does not contain any toxic chemicals which are subject to reporting under Section 313 of SARA Title III (40 CFR Part 372).

WASTE DISPOSAL METHODS: Consult with regulatory agencies or corporate personnel for disposal methods that comply with local, state, and federal health and environmental regulations.

HEALTH / SAFETY CONTACTS:
Steve Gerrard (x6309)
Jerry Metcalf (x6704)

The information and recommendations contained herein are based upon data believed to be correct; however, no guarantee or warranty of any kind expressed or implied is made with respect to the information provided.